Table of Contents
Advertisement
Annunciations & Alerts
Message
COM2 TEMP – COM2 over temp.
Reducing transmitter power.
CONFIRM BARO QFE – Confirm
BARO QFE Reference Elevation
DATA LOST – Pilot stored data was
lost. Recheck settings.
DATABASES EXPIRED – Restart
avionics to activate standby
databases.
DATABASES MISMATCHED –
Restart displays to correct mismatch.
DB CHANGE – Database changed.
Verify stored airways.
DB CHANGE – Database changed.
Verify user modified procedures.
DB MISMATCH – Navigation
database mismatch. Xtalk is off.
DB MISMATCH – Obstacle
database mismatch.
200
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Comments
The system has detected an over temperature condition in
COM2. The transmitter operates at reduced power. If the
problem persists, the system should be serviced.
Confirm BARO QFE Reference Elevation.
The pilot profile data was lost. System reverts to default pilot
profile and settings. The pilot may reconfigure the MFD & PFD
with preferred settings, if desired.
The databases in the system have expired. Restart the system
move the standby databases to active status.
The GDUs have different database versions or regions. Restart
the system move the standby databases to active status.
This occurs when a stored flight plan contains an airway that is
no longer consistent with the navigation database. This alert is
issued only after an navigation database update. Verify use of
airways in stored flight plans and reload airways as needed.
This occurs when a stored flight plan contains a procedure that
is no longer consistent with the navigation database. This alert
is issued only after an navigation database update. Verify that
the user-modified procedures in stored flight plans are correct
and up to date.
The PFDs and MFD have different navigation database versions
or regions installed. Crossfill is off. Check the 'Aux-System
Status' Page to determine versions or regions. Also, check
the 'Aux-System Status' Page for a database synchronization
function not completed. After synchronization is complete,
power must be turned off, then on.
The PFDs and MFD have different obstacle database versions
or regions installed. Check the 'Aux-System Status' Page to
determine versions or regions. Also, check the 'Aux-System
Status' Page for a database synchronization function not
completed. After synchronization is complete, power must be
turned off, then on.
190-02040-01 Rev. B
Advertisement
Table of Contents
