Garmin Beechcraft 200 Series Cockpit Reference Manual page 230

Hide thumbs Also See for Beechcraft 200 Series:
Table of Contents

Advertisement

Annunciations & Alerts
Message
GRS1 MANIFEST – GRS1 software
mismatch, communication halted.
GRS2 MANIFEST – GRS2 software
mismatch, communication halted.
GSD1 CONFIG – GSD1 config error.
Config service req'd.
GSD1 COOLING – GSD1
temperature too low.
GSD1 MANIFEST – GSD1 software
mismatch. Communication halted.
GSD1 SERVICE – GSD1 needs
service. Return unit for repair.
GSR1 FAIL – GSR1 has failed.
GTS CONFIG – GTS Config error.
Config service req'd.
GTS MANIFEST – GTS software
mismatch, communication halted.
GTX1 MANIFEST – GTX1 software
mismatch, communication halted.
GTX2 MANIFEST – GTX2 software
mismatch, communication halted.
GWX CONFIG – GWX config error.
Config service req'd.
GWX FAIL – GWX is inoperative.
GWX MANIFEST – GWX software
mismatch, communication halted.
GWX SERVICE – Needs service.
Return unit for repair.
HDG FAULT – AHRS1 magnetometer
fault has occurred.
HDG FAULT – AHRS2 magnetometer
fault has occurred.
206
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
Comments
The #1 AHRS has incorrect software installed. The system
should be serviced.
The #2 AHRS has incorrect software installed. The system
should be serviced.
GSD1 and the CDU have different copies of the GSD1
configuration.
GSD1 is reporting a low temperature condition.
GSD1 has incorrect software installed. The system should be
serviced.
GSD1 is reporting an internal error condition. The GSD may still
be usable.
A failure has been detected in the #1 GSR 56. The system
should be serviced.
The GTS and GDU have different copies of the GTS
configuration, or the Mode S address is invalid. The system
should be serviced.
The GTS has incorrect software installed. The system should be
serviced.
The transponder has incorrect software installed. The system
should be serviced.
The transponder has incorrect software installed. The system
should be serviced.
GWX configuration settings do not match those of the GDU
configuration. The system should be serviced.
The GDU is not receiving status packet from the GWX is
reporting a fault. The GWX radar system should be serviced.
The GWX has incorrect software installed. The system should
be serviced.
A failure has been detected in the GWX. The GWX may still be
usable.
A fault has occurred in the #1 GMU 44. Heading is flagged as
invalid. The AHRS uses GPS for backup mode operation. The
system should be serviced.
A fault has occurred in the #2 GMU 44. Heading is flagged as
invalid. The AHRS uses GPS for backup mode operation. The
system should be serviced.
190-02040-01 Rev. B

Advertisement

Table of Contents
loading

This manual is also suitable for:

Beechcraft b200 seriesG1000 nxi

Table of Contents