Table of Contents
Advertisement
Flight Instruments
9) Turn the large FMS Knob to highlight the Flight Level field.
10) Use the FMS Knobs to change the Flight Level for the alert and press the
ENT Key to accept or press the CLR Key to return to the previous altitude
selection.
11) Push the FMS Knob to deactivate the cursor.
Setting the BARO QFE while on the ground:
1) Set the appropriate QFE BARO setting on both PFDs.
2) Use the FMS Knob to select the 'Aux - System Setup 1' Page on the MFD.
3) Press the FMS Knob to activate the cursor.
4) Turn the large FMS Knob to select the 'REF' field in the BARO QFE Box.
5) Use the small FMS Knob to select 'Manual' or 'FMS ORIG', and press the
ENT Key to accept.
6) If 'Manual' was selected, use the FMS Knobs to enter the field elevation of
the departure airport in the 'ELEV' field and press the ENT Key.
7) If 'FMS ORIG' was selected, the field elevation of the selected departure
airport/runway from the flight plan will be shown in the BARO QFE Box.
Verify this information is correct.
8) The 'On/Off' Field will automatically highlight, turn the small FMS Knob to
change the selection from 'Off' to 'On'.
9) Push the FMS Knob to deactivate the cursor. QFE mode is now active.
Change the BARO setting on both PFDs to STD BARO to disable BARO QFE.
Setting the BARO QFE while in flight:
NOTE: Changing the BARO setting with the autopilot engaged in ALT mode
will result in the aircraft slowly climbing or descending to return to the original
indicated altitude.
1) Set the BARO setting to STD BARO on both PFDs.
2) Use the FMS Knob to select the 'Aux - System Setup 1' Page on the MFD.
3) Press the FMS Knob to activate the cursor.
4) Turn the large FMS Knob to select the 'REF' field in the BARO QFE Box.
5) Use the small FMS Knob to select 'Manual' or 'FMS DEST', and press the
ENT Key to accept.
4
Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series
190-02040-01 Rev. B
Advertisement
Table of Contents
