Table of Contents
Advertisement
Attention: Do not use any tools or sharp objects to lift the release levers on
the microprocessor socket. Doing so might result in permanent damage to the
system board.
7. Open the microprocessor socket release levers and retainer.
a. Open the release lever on the microprocessor socket.
b. Open the microprocessor retainer.
Note: Do not touch the microprocessor contacts. Contaminants on the
microprocessor contacts, such as oil from your skin, can cause connection
failures between the contacts and the socket.
8. Install the microprocessor on the microprocessor installation tool:
Note: If you are replacing a microprocessor, use the empty installation tool
that comes with the new microprocessor to remove the microprocessor.
a. Twist the handle on the microprocessor tool counterclockwise so that it is
in the open position.
b. Align the installation tool with the alignment pins on the microprocessor
socket and lower the tool on the microprocessor. The installation tool rests
flush on the socket only if aligned correctly.
Chapter 5. Removing and replacing blade server components
83
Advertisement
Table of Contents
