Lenovo BladeCenter HS23E Problem Determination And Service Manual page 150

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing," on page 41 to determine which components are consumable, structural, or CRU
parts.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
Error Code Event ID
0x80070200 80070202-0701ffff
0x80070200 80070202-1001ffff
80070202-1002ffff
80070202-1003ffff
80070202-1004ffff
0x80070200 80070217-1001ffff
80070217-1002ffff
80070217-1003ffff
80070217-1004ffff
136
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
Type Error Message
Error System board,
voltage (SysBrd Vol
Fault) critical
Error Expansion Module
0 or 2, voltage
(BPE4_X_VOL)
critical [Note:
X=1-4]
Error Expansion Module
0 or 2, Expansion
Card (BPE4_X
Fault) critical [Note:
X=1-4]
Action
1. Reseat the blade server in the
BladeCenter unit (see "Removing the
blade server from the BladeCenter unit"
on page 49 and "Installing the blade
server in a BladeCenter unit" on page 50).
2. If the error continues, replace the
system-board assembly (see "Removing
the system-board assembly" on page 90
and "Installing the system-board
assembly" on page 91).
1. If the under voltage problem is occurring
on all blade servers, look for other events
in the IMM2 event log related to power
and resolve those events (see "Event
logs" on page 96).
2. View the event log provided by the
advanced management module for your
BladeCenter unit and resolve any power
related errors that might be displayed.
3. If other modules or blades are logging
the same issue then check the system
power supply, otherwise replace the
Blade PCI Express I/O expansion unit.
See "Removing an optional expansion
unit" on page 79 and "Installing an
optional expansion unit" on page 80.
1. View the event log provided by the
advanced management module for your
BladeCenter unit and resolve any
expansion card related errors that might
be displayed.
2. If other modules or blades are logging
the same issue then check the power
supply for the BladeCenter unit.
3. If the error still occurs, replace the
system-board assembly (see "Removing
the system-board assembly" on page 90
and "Installing the system-board
assembly" on page 91).