Table of Contents
Advertisement
v See Chapter 4, "Parts listing," on page 41 to determine which components are consumable, structural, or CRU
parts.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
Error code
Description
405-902-xxx
Failed the EEPROM test. A failure was
detected while testing non-volatile RAM.
405-003-xxx
Passed the InternalMemory test.
405-903-xxx
Failed the InternalMemory test. A failure was
detected while testing internal memory.
405-004-xxx
Passed the Interrupt test.
405-904-xxx
Failed the Interrupt test. A failure was
detected while testing interrupts.
405-005-xxx
Passed the LoopbackAtMACLayer test.
Action
1. Make sure that the component firmware or
driver is installed correctly, upgrade if necessary.
The installed firmware level can be found in the
DSA Diagnostic Event Log within the
Firmware/VPD section for this component. The
latest level firmware for this component can be
found in reference to this system type at
http://www.ibm.com/support/
docview.wss?uid=psg1MIGR-4JTS2T.
2. Rerun the test.
3. If the failure remains, refer to
http://www.ibm.com/support/
docview.wss?uid=psg1SERV-OPTN for the
corrective actions.
N/A
1. Make sure that the component firmware or
driver is installed correctly, upgrade if necessary.
The installed firmware level can be found in the
DSA Diagnostic Event Log within the
Firmware/VPD section for this component. The
latest level firmware for this component can be
found in reference to this system type at
http://www.ibm.com/support/
docview.wss?uid=psg1MIGR-4JTS2T.
2. Rerun the test.
3. If the failure remains, refer to
http://www.ibm.com/support/
docview.wss?uid=psg1SERV-OPTN for the
corrective actions.
N/A
1. Make sure that the component firmware or
driver is installed correctly, upgrade if necessary.
The installed firmware level can be found in the
DSA Diagnostic Event Log within the
Firmware/VPD section for this component. The
latest level firmware for this component can be
found in reference to this system type at
http://www.ibm.com/support/
docview.wss?uid=psg1MIGR-4JTS2T.
2. Rerun the test.
3. If the failure remains, refer to
http://www.ibm.com/support/
docview.wss?uid=psg1SERV-OPTN for the
corrective actions.
N/A
199
Chapter 6. Diagnostics
Advertisement
Table of Contents
