Lenovo BladeCenter HS23E Problem Determination And Service Manual page 130

116
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
v Follow the suggested actions in the order in which they are listed in the Action
column until the problem is solved.
v See Chapter 4, "Parts listing," on page 41 to determine which components are
consumable, structural, or CRU parts.
v If an action step is preceded by "(Trained technician only)," that step must be
performed only by a trained technician.
Diagnostic
code Message
S.2011001 [S.2011001] An
Uncorrected PCIe
Error has Occurred
at Bus % Device %
Function %. The
Vendor ID for the
device is % and the
Device ID is %.
S.2018001 [S.2018001] An
Uncorrected PCIe
Error has Occurred
at Bus % Device %
Function %. The
Vendor ID for the
device is % and the
Device ID is %.
Description Action
PCI SERR
1. Reseat the expansion card (see
Detected.
"Removing an I/O expansion
card" on page 71 and "Installing
an I/O expansion card" on page
73).
2. Check the IBM support website
for an applicable retain tip or
firmware update that applies to
this error.
3. If the problem still remains,
remove the expansion card. If the
system restart successfully
without the expansion card,
replace the expansion card (see
"Removing an I/O expansion
card" on page 71 and "Installing
an I/O expansion card" on page
73).
4. (Trained technician only) Replace
the microprocessor (see
"Removing a microprocessor and
heat sink" on page 81 and
"Installing a microprocessor and
heat sink" on page 84).
PCIe Uncorrected
1. Reseat the expansion card (see
Error Detected.
"Removing an I/O expansion
card" on page 71 and "Installing
an I/O expansion card" on page
73).
2. Check the IBM support website
for an applicable retain tip or
firmware update that applies to
this error.
3. If the problem still remains,
remove the expansion card. If the
system restart successfully
without the expansion card,
replace the expansion card (see
"Removing an I/O expansion
card" on page 71 and "Installing
an I/O expansion card" on page
73).
4. (Trained technician only) Replace
the microprocessor (see
"Removing a microprocessor and
heat sink" on page 81 and
"Installing a microprocessor and
heat sink" on page 84).