Lenovo BladeCenter HS23E Problem Determination And Service Manual page 154

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing," on page 41 to determine which components are consumable, structural, or CRU
parts.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
Error Code Event ID
0x80070600 8007060f-2201ffff
0x80070600 8007060f-2201ffff
0x800b0100 800b010c-2581ffff
0x800b0300 800b030c-2581ffff
0x800b0500 800b050c-2581ffff
140
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
Type Error Message
Error FW/BIOS, firmware
progress (BOFM cfg
Err) non-recoverable
Error FW/BIOS, firmware
progress (TPM Init
Err) non-recoverable
Error Redundancy Lost
for (Backup
Memory) has
asserted.
Warning Non-redundant:
Sufficient Resources
from Redundancy
Degraded or Fully
Redundant for
(Backup Memory)
has asserted.
Error Non-redundant:
Insufficient
Resources for
(Backup Memory)
has asserted.
Action
Install the latest UEFI firmware (see
"Updating firmware and device drivers" on
page 31).
Install the latest UEFI firmware (see
"Updating firmware and device drivers" on
page 31).
1. Check the event logs for other memory
errors that might occur (see "Event logs"
on page 96).
2. Reseat all of the memory modules in the
blade server (see "Removing a memory
module" on page 65 and "Installing a
memory module" on page 66).
3. Make sure all of the memory is enabled
in the Setup utility (see "Using the Setup
utility" on page 18). Notice which
memory modules are disabled before
continuing to the next step.
1. Check the event logs for other memory
errors that might occur (see "Event logs"
on page 96).
2. Reseat all of the memory modules in the
blade server (see "Removing a memory
module" on page 65 and "Installing a
memory module" on page 66).
3. Make sure all of the memory is enabled
in the Setup utility (see "Using the Setup
utility" on page 18). Notice which
memory modules are disabled before
continuing to the next step.
1. Check the event logs for other memory
errors that might occur (see "Event logs"
on page 96).
2. Reseat all of the memory modules in the
blade server (see "Removing a memory
module" on page 65 and "Installing a
memory module" on page 66).
3. Make sure all of the memory is enabled
in the Setup utility (see "Using the Setup
utility" on page 18). Notice which
memory modules are disabled before
continuing to the next step.