Lenovo BladeCenter HS23E Problem Determination And Service Manual page 232

10. Perform the firmware update by following the instructions that are in the
11. Copy the downloaded firmware update package into a directory.
12. From a command line, type filename-s, where filename is the name of the
13. Reboot the server and verify that it completes POST (see "Turning off the
14. Turn off the server (see "Turning off the blade server" on page 12).
15. Remove the blade server form the BladeCenter unit (see "Removing the blade
16. Remove the server cover. See "Removing the blade server cover" on page 52.
17. Move the UEFI boot block recovery switch (SW1-5) to the OFF position (see
18. Replace the cover and reinstall the blade server in the BladeCenter unit,
19. Restart the blade server (see "Turning off the blade server" on page 12 and
20. Remove the blade server form the BladeCenter unit (see "Removing the blade
21. Remove the server cover. See "Removing the blade server cover" on page 52.
22. Reset the CMOS by removing the battery (see "Removing the battery" on
23. Leave the battery out of the server for 5 minutes.
24. Reinstall the CMOS battery (see "Installing the battery" on page 62.
25. Replace the cover and reinstall the blade server in the BladeCenter unit,
26. Restart the blade server (see "Turning off the blade server" on page 12 and
The system begins the power-on self-test (POST).
218
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
8. Restart the blade server (see "Turning on the blade server" on page 11). The
system begins the power-on self-test (POST).
9. Boot the server to an operating system that is supported by the firmware
update package that you downloaded.
firmware update package readme file.
executable file that you downloaded with the firmware update package.
blade server" on page 12).
server from the BladeCenter unit" on page 49).
"System-board switch" on page 13).
making sure that the media tray is selected by the relevant blade server. See
"Installing the blade server cover" on page 53 and "Installing the blade server
in a BladeCenter unit" on page 50.
"Turning on the blade server" on page 11). The system begins the power-on
self-test (POST).If this does not recover the primary bank continue with the
following steps.
server from the BladeCenter unit" on page 49).
page 61.
making sure that the media tray is selected by the relevant blade server. See
"Installing the blade server cover" on page 53 and "Installing the blade server
in a BladeCenter unit" on page 50.
"Turning on the blade server" on page 11).