Table of Contents
Advertisement
2. Install all of the components in the following list that you removed from the
3. Install the optional expansion unit, if you removed one from the blade server to
4. Install the cover onto the blade server (see "Installing the blade server cover"
5. Install the blade server into the BladeCenter unit (see "Installing the blade
6. The Universal Unique Identifier (UUID) must be updated when the system
7. Update the server with the latest firmware or restore the pre-existing firmware
92
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
old system-board assembly onto the new system-board assembly.
v DIMMs. See "Installing a memory module" on page 66.
v USB module. See "Installing a USB Flash key" on page 70.
v I/O expansion cards. See "Installing a CIOv-form-factor expansion card" on
page 73, "Installing a horizontal-compact-form-factor expansion card" on
page 74, and"Installing a storage interface card" on page 76.
v Storage drives. See "Installing a hot-swap storage drive" on page 64.
v Microprocessors and heat sinks. See "Installing a microprocessor and heat
sink" on page 84.
replace the battery (see "Installing an optional expansion unit" on page 80 for
instructions).
on page 53).
server in a BladeCenter unit" on page 50).
board is replaced. Use the Advanced Settings Utility to update the UUID in the
UEFI-based server (see "Updating the Universal Unique Identifier (UUID)" on
page 23).
that the customer provides on a diskette or CD image. Make sure that you have
the latest firmware or a copy of the pre-existing firmware before you proceed.
See "Updating the DMI/SMBIOS data" on page 25 and "Updating firmware
and device drivers" on page 31 for more information.
Advertisement
Table of Contents
