Table of Contents
Advertisement
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing," on page 41 to determine which components are consumable, structural, or CRU
parts.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
Error Code Event ID
0x806f011b 806f011b-0c01ffff
806f0123-2101ffff
0x806f0207 806f0207-0301ffff
806f0207-0302ffff
Type
Error Message
Error
The connector
(Front Panel) has
encountered a
configuration error.
Info
Reboot of system
initiated by IPMI
Watchdog.
Error
Processor X, (CPU
X) has failed with
FRB1/BIST
condition. [Note:
X=1,2]
Action
1. Reseat the control-panel cable (see
"Removing the control panel" on page 77
and "Installing the control panel" on
page 78).
2. Replace the front bezel (see "Removing
the bezel assembly" on page 54 and
"Installing the bezel assembly" on page
55).
3. (Trained technician only) Replace the
system-board assembly (see "Removing
the system-board assembly" on page 90
and "Installing the system-board
assembly" on page 91).
Information only; no action is required.
1. Remove the blade server and ensure the
processors are installed correctly (see
"Installing a microprocessor and heat
sink" on page 84).
2. Verify that the system is running the
latest UEFI firmware (see "Updating
firmware and device drivers" on page
31).
3. Run the Setup utility (see "Using the
Setup utility" on page 18).
a. Make sure that both processors are
displayed by the system.
b. Load the default settings.
c. Go to the System Settings menu and
make sure the processor is enabled.
4. (Trained technician only) If the problem
continues, replace the processor (see
"Removing a microprocessor and heat
sink" on page 81 and "Installing a
microprocessor and heat sink" on page
84).
5. (Trained technician only) If the error
continues, replace the system-board
assembly (see "Removing the
system-board assembly" on page 90 and
"Installing the system-board assembly"
on page 91).
Chapter 6. Diagnostics
151
Advertisement
Table of Contents
