Table of Contents
Advertisement
v Follow the suggested actions in the order in which they are listed in the Action
column until the problem is solved.
v See Chapter 4, "Parts listing," on page 41 to determine which components are
consumable, structural, or CRU parts.
v If an action step is preceded by "(Trained technician only)," that step must be
performed only by a trained technician.
Diagnostic
code
Message
W.305800D [W.305800D] Driver
health protocol:
Disconnect
controller failed.
Requires "reboot".
W.305800E [W.305800E] Driver
health protocol:
Reports invalid
health status driver.
S.3060007
[S.3060007] A
firmware fault has
been detected in
the UEFI image.
S.3070007
[S.3070007] A
firmware fault has
been detected in
the UEFI image.
S.3108007
[S.3108007 ] The
default system
settings have been
restored.
Description
Action
DRIVER HEALTH
1. Restart the system.
PROTOCOL:
2. If the problem persists, switch to
Disconnect
the backup UEFI image or reload
Controller Failed.
the current UEFI image.
Requires 'Reboot'.
3. (Trained technician only) Replace
the system board (see "Removing
the system-board assembly" on
page 90 and "Installing the
system-board assembly" on page
91).
DRIVER HEALTH
1. Restart the system.
PROTOCOL:
2. If the problem persists, switch to
Reports Invalid
the backup UEFI image or reload
Health Status
the current UEFI image.
Driver.
3. (Trained technician only) Replace
the system board (see "Removing
the system-board assembly" on
page 90 and "Installing the
system-board assembly" on page
91).
Internal UEFI
1. Check the IBM support website
Firmware Fault
for an applicable retain tip or
Detected, System
firmware update that applies to
halted.
this error.
2. Recover the server firmware (see
"Recovering from a UEFI update
failure" on page 217).
Internal UEFI
1. Check the IBM support website
Firmware Fault
for an applicable retain tip or
Detected, System
firmware update that applies to
halted.
this error.
2. Recover the server firmware (see
"Recovering from a UEFI update
failure" on page 217).
System
1. Check the IBM support website
Configuration
for an applicable retain tip or
Restored to
firmware update that applies to
Defaults.
this error.
2. If the settings differ from
defaults, run the Setup utility,
select Load Default Settings, and
save the settings.
123
Chapter 6. Diagnostics
Advertisement
Table of Contents
