Configure Router Ldp Interface-Parameters Interface - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

configure router ldp interface-parameters interface

Configures LDP support on the specified IP interface.
configure router ldp interface-parameters interface ip-intf-name
configure router ldp interface-parameters no interface ip-intf-name
Syntax Definitions
ip-intf-name
Defaults
By default, the LDP interface is administratively enabled when the interface is created.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
•
Use the no form of this command to remove the LDP configuration from the IP interface. Disable the
administrative status of the interface before attempting to remove it.
•
The IP interface name specified with this command must already exist in the router configuration.
•
Until LDP support is configured on an IP interface, no other LDP configuration tasks are allowed on
that interface.
Examples
-> configure router ldp interface-parameters interface vlan-14
-> configure router ldp interface-parameters no interface vlan-14
Release History
Release 6.4.2; command was introduced.
Related Commands
configure router ldp interface-
parameters interface shutdown
show router ldp interface
show router ldp parameters
page 48-4
The name of an existing IP interface.
Configures the administrative status for the specified LDP interface.
Displays the LDP interface configuration for the router.
Displays global LDP parameter values for the router.
MPLS LDP Commands
OmniSwitch CLI Reference Guide June 2012