Nortel Call Center Set Up And Operation Manual page 100

100 Chapter 7 Off-premise Message Notification
<start time>
RETRY
Stop hhmm:
RETRY
<stop time>
RETRY AM
<stop time>
RETRY
More dest?
YES NO
Notify2: none
SETUP
Destination:
PHONE EXT
Pager:
RETRY
<xxxx>
ADD
Show<xxxx>
CHNG
Notify2: pager
CHNG OTHR
Notify 3: none
SETUP
N0008709 04
Press OK or £ to accept the start time.
9
OK
10 Enter the time when Off-premise Message Notification is to stop.
OK
This is a four digit field. Any single digit hour and minute must be
preceded by a zero.
11 Press AM or ⁄
PM
or
PM or ¤.
12 Press OK or £ to accept the stop time.
OK
13 Press YES or ⁄ to set up another destination number.
14 Press SETUP to set up another destination number.
NEXT
15 Press PAGER or ‹ to select a pager number destination.
PAGER
16 Enter the destination pager number and press OK or £.
OK
17 Press OK or £ to accept the destination pager number represented
OK
by <x>
or
press ADD or ¤ to add special characters and use your dialpad or
follow the voice prompts to add characters.
After you add special characters, press OK or £.
18 Press NEXT or £ to accept the default pager message represented
NEXT
by <xxxx>. The default pager message sent by CallPilot is the
CallPilot extension. This is the sequence of digits that is sent after
the pager service is dialed, to notify you of who is paging you
or
press CHNG or ⁄ to change the pager message.
The combined limit is 30 characters for the pager phone number
and the pager message.
19 The display shows that the second destination is a pager.
NEXT
Press NEXT or £ to continue.
20 Press NEXT or £ to continue
NEXT
or
press SETUP to add another destination.