Ip Show Commands; Show Ip Adjacent-Hosts; Show Ip Alerts - Nortel Versalar 15000 Reference Manual

IP Show Commands

This section describes the IP show commands and the command options you can
enter. It also describes the information in the tables the router displays.

show ip adjacent-hosts

The
hosts. The table includes the following information:
Host Address
Encaps
Valid ?
State
MAC Address
WAN Address
Sub-address
Type of Number

show ip alerts

The
interfaces whose state does not match their configuration, for example, an
interface configured as enabled but whose state is not up. The output includes the
following information:
Circuit
Circuit #
State
IP Address
Mask
308689-B Rev 00
show ip adjacent-hosts
command displays the circuit name and IP address of
show ip alerts
command displays a table of configured adjacent
IP address of the adjacent host (applies to both single
and expanded).
Encapsulation method used: ENET (Ethernet), SNAP
(Subnetwork Access Protocol), PDN (Public Data
Network), or DDN (Defense Data Network).
Validity of the configuration. If this field displays No, you
should check the adjacent host's configuration.
Status of the adjacent host: enabled or disabled.
Media access control (MAC) address of the host.
Physical address of the adjacent host.
Subaddress used to establish a switched virtual circuit
(SVC) to the adjacent host.
Type of number used to establish an SVC to the adjacent
host.
Name of the circuit associated with the IP interface.
Number of the circuit in the router's active MIB.
Status of the IP interface: up or down.
IP address of the interface.
Subnet mask of the IP interface.
show ip adjacent-hosts
75