Show Controllers T3 - Nortel Versalar 15000 Reference Manual

HCS errors
Correctable HCS errors
Uncorrectable HCS errors

show controllers t3

The
interfaces on the router and the data received and sent by the router.
This command allows for the following arguments:
slot/connector
The output displays the following information:
T3
Slot/Conn
Processor H/W Rev
Processor Ser No
Interface H/W Rev
Interface Ser No
Admin State
Applique Type
Alarm
Framing
Line Code
Clock Source
T3 Current Interval
Slot/Conn
Time Elapsed
LCV
PCV
CCV
308689-B Rev 00
show controllers t3
Number of correctable HCS (header check sum) errors.
Number of uncorrectable HCS errors.
show command gives information about the T3
Displays the slot and connector number of the interface.
Identifier for the slot and connector.
Hardware version of the T3 board.
Serial number of the Channelize Access Processor.
Hardware version of the Physical Interface.
Serial number of the Physical Interface.
State of the controller: up or down.
Type of controller.
Number of active alarms.
Type of frames in which data is packaged.
Format of line coding.
Timing reference source.
Identifier for the slot and connector.
Number of seconds elapsed in the current interval.
Number of line code violations.
Number of path code violations.
Number of C-bit code violations.
show controllers t3
33