Table of Contents
Advertisement
82
Chapter 5 Managing the Passport 8672ATM Module with the CLI
Figure 27 Sample output for the config atm info command
number-vpi-bits : 4
Show commands
This section discusses the CLI show commands available with the Passport
8672ATM Module. These commands allow you to view information about the
module:
show ports info atm all [<ports>]
show ports info atm ports [<ports>]
show ports info atm pvc [<ports>]
show ports info atm 1483 [<ports>]
show ports stats atmport [<ports>]
show ports stats atm felinecurrent [<ports>]
show ports stats atm felineinterval <intervalid> [<ports>]
show ports stats atm fepathcurrent [<ports>]
show ports stats atm fepathinterval <intervalid> [<ports>]
show ports stats atm linecurrent [<ports>]
show ports stats atm lineinterval <intervalid> [<ports>]
show ports stats atm pathcurrent [<ports>]
show ports stats atm pathinterval <intervalid> [<ports>]
show ports stats atm sectioncurrent [<ports>]
show ports stats atm sectioninterval <intervalid> [<ports>]
show ports stats atm sonetmediumtbl [<ports>]
Refer to Reference for the Passport 8000 Series Command Line Interface
Switching Operations, and Reference for the Passport 8000 Series Command Line
Interface Routing Operations for a complete list of CLI show commands.
show ports info atm all command
This command displays information
specified port or for all ports. The command uses the syntax:
show ports info atm all [<ports>]
209195-A
scrambling : Enable
framing-mode : SONET
clock-source : Free Running
loop-back-mode : off
state : up
(Figure 28)
about the configuration for the
Advertisement
Table of Contents
