Show T1 Ds1 Summary - Nortel Versalar 15000 Reference Manual

show t1 ds1 summary

The
MCT3 and MCOC3 channels, or for a specific slot. This command allows for the
following options:
-slot <value>
<value>
value is any of the
following:
<slot>
<slot/conn>
<slot/conn/chan>
The output includes the following information:
T1 over Mct3 summary
Mct3 Channel
Administrative State
Operational State
Alarms
Pri/Sec Clock
Actual Clock
MTU
Framing
Setup Alarm Threshold
Clear Alarm Threshold
Fdl Address
308689-B Rev 00
show t1 ds1 summary
command displays summary information for all
Displays summary information for the specified slot only.
Displays information for the specified
slot/connector/channel.
Identifier for the slot, DS3 connector, and T1 channel.
Current administrative state.
Current operational state.
Current alarm state.
Configured primary/secondary source of the Tx clock for
the MCT3 channel interface.
Clock source currently in use by the MCT3 channel
interface.
Largest frame size that can be received by the MCT3
channel. Anything larger than the MTU will be discarded.
Framing mode. Possible values here are extended
superframe (ESF) or superframe (SF).
Minimum amount of time required before entering (or
exiting) an alarm state due to changes on the DS1.
One of two Facility Data Link (FDL) target address
modes. It determines whether the near-end FDL will
respond to High Level Data Link Control (HDLC) address
AZ or BY in the FDL messages received from the far end.
show t1 ds1 summary
157