Nortel Versalar 15000 Reference Manual page 188

show t1 summary
The Admin/Oper State output field indicates whether or not the queue is up. In the
first example that follows, the queue within the service package has been created
successfully, but it has not come up on the line. The line is in state quemisCfg
because there is a conflicting class and the queue is improperly configured. In
such cases, the Versalar 15000 has run out of available queues.
show t1 summary T1-1/3/28
T1 Summary
---------------------------------------------------------------
Name Slot/Conn/
Channel
------ ------
T1-1/3/28 1/3/28
In the case of multiple queues, the
the fourth queue on the line is not configured properly. If so, the T1 line attempts
to get only three queues and not four. Thus, if the state of the line is up, the T1 line
gets all 3 queues. By contrast, if the configuration is incorrect and you attempt to
use more queues than the access card can distribute, the T1 line enters a queue
misconfigured state.
The
that the line did not come up. In such cases, there are three queues created
successfully within the service package. All three queues have not come up on the
line, however. Unless the driver is able to obtain all of the queues for a line, it will
not come up successfully.
show t1 summary T1-1/3/28
T1 Summary
---------------------------------------------------------------
Name Slot/Conn/
Channel
------ ------
T1-1/3/28 1/3/28
168
Admin/Oper
State
---------
enabled/
quemisCfg
show t1 summary command then produces the following output indicating
Admin/Oper
State
---------
enabled/
quemisCfg
QoS WAN
Package Protocol
----- -----
four-queue ppp
show t1 summary
QoS WAN
Package Protocol
----- -----
four-queue ppp
CRC Rate
Adaption
------
---
CRC-16 64K
command may indicate that
CRC Rate
Adaption
------
---
CRC-16 64K
308689-B Rev 00