Additional Equipment; Tools; Cables; Management Console - Nortel Passport 2430 Installing And Operating Instructions

Installing and Operating the Passport 2430 Multiservice Access Switch

Additional Equipment

Before installing the Passport 2430 hardware, ensure that you obtain all the
cables, tools, and other equipment that you need.

Tools

To install a WAN adapter you need a Phillips screwdriver to remove the filler
panel.
To wall-mount the Passport 2430, you need the following tools:
• Phillips screwdriver
• Carpenter's level
To rack-mount the Passport 2430, you need a Phillips screwdriver to assemble the
shelf unit and attach the shelf unit to an equipment rack.

Cables

Unless they were specifically ordered, the cables necessary for your network
configuration are not part of the Passport 2430 accessory package. If you do not
have the proper cables, contact your network administrator or see the Cable
Guide.

Management Console

Before you boot the Passport 2430 for the first time, you need to attach a terminal
or PC to the Passport 2430 to monitor the results of startup diagnostics and
perform manual boot configurations. If you use a terminal as your management
console, you need a DB-9 to DB-25 adapter to connect the router to the terminal.
After the initial start-up, you can use the PCMCIA modem for remote dial-in
access to the Passport 2430.
1-8
308224-B Rev 00