Ppp Show Commands; Show Ppp Alerts - Nortel Versalar 15000 Reference Manual

PPP Show Commands

This section describes the PPP show commands and the command options you
can enter. It also describes the information in the tables the router displays.

show ppp alerts

The
but whose state is not opened. This command allows for the following options:
-name <value>
-slot <value>
The output includes the following information:
Name
Slot/Conn/Channel
Line State
Protocol
308689-B Rev 00
command displays all circuits using PPP that are enabled
show ppp alerts
Displays protocol information for only the named circuit.
Displays protocol information for only the specified slot.
Name of the circuit.
Identifier for the slot, DS3 connector, and DS1 the
protocol runs on.
State of the line, which can be one of the following:
• Down -- Line is not operational.
• DSR Wait -- External equipment, such as a modem,
DSU, or CSU, is not currently up and thus is not
sending a Data Set Ready signal.
• HoldDown -- Line is in holding mode.
• Init -- Line is initializing.
• LMI Wait -- Line is waiting for the WAN protocol to
indicate that a link layer connection has been
established to another device.
• Not Pres -- Line is enabled but not active. This state
occurs for several reasons. For example, the Link
Module may not be physically present in the chassis.
The software may be booting and has not yet
initialized. The slot may be running diagnostics or
there may be a problem with the configuration.
• Up -- Line is operating normally.
Currently active protocol on this circuit.
show ppp alerts
129