Show T3 Sample - Nortel Versalar 15000 Reference Manual

show t3 sample

Queue Status
Queue Weight
CIR/BR (kbits/sec)
show t3 sample
The
stats
This command allows for the following options:
-slot <arg>
-name <arg>
-period <arg>
<arg 1>
The output includes the following information:
T3 over Mct3 sample
Name
Slot/Conn
Bits/sec Received/Transmitted Number of bits per second transmitted and received
Frames/sec
Received/Transmitted
Drops/sec Receive/Transmit
184
command displays the same information as the
show t3 sample
command, but only displays the data captured in a specified time interval.
State of the queue within the service package:
• up -- queue is good (that is, it is properly configured
and the service package is created)
• waitPkg -- queue is created, but the service package
is not
• misCfg -- queue is improperly configured (for
example, there is a conflicting class)
Weight value assigned to the queue.
Committed information rate (CIR)/burst rate (BR).
Displays information about the specified slot only.
Displays information about the specified T3 circuit.
Displays data sampled during the period (number of
seconds) specified. If no period is specified, the default
period (10 seconds) is used.
Displays information about the specified circuit name.
The circuit number that this interface runs over.
Identifier for the slot and connector.
without error.
Number of frames per second transmitted and received
without error.
Number of drops per second transmitted and received
without error.
show t3
308689-B Rev 00