Show Bgp Timers - Nortel Versalar 15000 Reference Manual

Dynamic Policy Change
Multi-Hop
Detect Redundant Connections
Cluster ID
Injection-time (sec)
Max Redundant Routes
Soloist Slot
Blackhole Support
Med Comparison
Total Routes
Used Routes
Total Paths

show bgp timers

The
allows for the following command filter (flag) and filter arguments:
-remote-address
<value>
<value>
308689-B Rev 00
show bgp timers command displays BGP timer values. This command
Whether dynamic policy change is enabled or
disabled.
Whether multihop is enabled or disabled.
Whether redundant connection detection is enabled or
disabled.
Associate the IBGP route reflector with a cluster.
Minimum interval (in seconds) between route
injections into the routing table.
Maximum number of redundant routes that BGP
received and used, and the total number of redundant
routes.
Indicates whether BGP is running as a soloist on the
specified slot.
Identifier for the blackhole support switch. Possible
values here are: disabled (1), drop (2), or reject (3). If
disabled , BGP does not submit a blackhole route to
the IP routing table for an aggregate route advertised
to a BGP peer. If drop , the packet will be dropped. If
reject , an ICMP Destination Unreachable message
will be sent back.
Identifier for the multi-exit discriminator (MED)
comparison switch. Possible values here are: enabled
(1) or disabled (2). If disabled , the MED route attribute
is not considered in the route selection process.
Total number of routes currently maintained.
Number of received BGP routes that have been
submitted for possible inclusion in the IP routing table.
Total number of BGP path attribute blocks currently
maintained.
Displays the routes that match only the specified remote IP
address.
Displays the routes that match only the specified value.
show bgp timers
25