Show Ppp Line Config - Nortel Versalar 15000 Reference Manual

The output includes the following information:
Name
State
Local Config
Local Address
Remote Address

show ppp line config

The
PPP line parameter values for the specified interface. This command allows for
the following options:
-name <value>
-slot <value>
The output includes the following information:
Name
Slot/Conn/Channel
LCP State
Restart Timer
Echo Req Freq
Echo Rep Loss
Max Conf Req
308689-B Rev 00
show ppp line config
Circuit for which this command displays information.
Operational state of the interface.
IP address that this router wants to use.
IP address that the peer router wants the local router to
use.
IP address that the remote peer wants to use.
command displays information about the configured
Displays protocol information for only the named circuit.
Displays protocol information for only the specified slot.
Circuit for which this command displays information.
Identifier for the slot, DS3 connector, and DS1.
Operational state of the Link Control Protocol (LCP).
Number of seconds that the restart timer waits before
retransmitting data.
Number of seconds that the router waits between the
transmission of echo-request packets.
Maximum number of unacknowledged echo-reply packets
that the router transmits before declaring the
point-to-point link down.
Maximum number of unacknowledged configure-request
packets that the router transmits before assuming that the
peer router on the other end of the link is unable to
respond.
show ppp line config
133