Show Ppp Bad-Packets - Nortel Versalar 15000 Reference Manual

Switch router
Hide thumbs Also See for Versalar 15000:
Table of Contents

Advertisement

show ppp bad-packets

State
show ppp bad-packets
The
received over each circuit and the first 16 bytes of the last bad packet. If the
number of bad packets is greater than zero, then the PPP circuit is receiving
misformed packets or packets meant for other protocols. The hexadecimal display
of the last bad packet will show the kind of packet being received.
130
show ppp bad-packets
State of the protocol, as follows:
Ackrcvd -- Acknowledgment received. The router
received an acknowledgment to its request for
configuring the connection. It has yet to acknowledge
the receipt of the request from the other side of the
connection.
Acksent -- Acknowledgment sent. The router has sent
a request for configuring the connection. It has also
acknowledged a similar request from the other side of
the connection, but has yet to receive an
acknowledgment of its request from the other side.
Closed -- Link is available but has not yet received an
"Open" request.
Closing -- Router has sent a request to close the
connection and is expecting an acknowledgment.
When it receives the acknowledgment, the connection
will enter the Closed state.
Initial -- Initial state; the lower layer is unavailable.
Opened -- Router has sent a configuration request
and the other side has acknowledged its request.
Also, the router has received a configuration request
from the other side and has acknowledged this
request. This layer is now up.
Reqsent -- Request sent. The router has sent a
request to configure the connection.
Starting -- Lower level is still unavailable but the router
has initiated an "Open" request.
Stopped -- Link is available and an "Open" event has
occurred. Upon receiving a request to configure the
connection, the router sends either an appropriate
response or acknowledges the termination request.
Stopping -- Router has sent a termination request to
close the open connection. When the router receives
an acknowledgment, the state changes to Stopped.
command displays the number of bad packets
308689-B Rev 00

Advertisement

Table of Contents
loading

Table of Contents