Show T3 Vc Qos Stats - Nortel Versalar 15000 Reference Manual

QoS Package
WAN Protocol
CRC

show t3 vc qos stats

The
packets and bytes transmitted and received over the frame relay DLCI VC (virtual
circuit) for queues configured through a service package.
You can specify any of the following filters (flags) with this command:
-slot <arg>
-name <arg>
<arg 1>
The output includes the following information:
T3 over Mct3 vc qos stats
Interface/DLCI
Cct/Queue
RxBelowCIR Packets/Octets
RxAboveCIR Packets/Octets
RxAboveBR Packets/Octets
Tx Packets/Octets
Dropped Packets
308689-B Rev 00
show t3 vc qos stats
QoS service package used by this circuit.
Indication of current protocol selection.
CRC size: CRC-32 (1), or CRC-16 (2).
• When you select CRC-32, a 32-bit CRC is appended
to the frame being transmitted and a 32-bit CRC
check is performed on the received frame.
• When you select CRC-16, a 16-bit CRC is appended
to the transmitted frame and a 16-bit CRC is
performed on the received frame.
command displays information about the number of IP
Displays information about the specified slot only.
Displays information about the specified T3 circuit.
Displays information about the specified circuit name.
Name of the circuit/number of the frame relay DLCI.
Circuit number/name of the queue from the Service
Package.
Number of packets/octets received that were below the
committed information rate (CIR).
Number of packets/octets received that exceeded the
CIR, but were within the allocated burst rate (BR).
Number of packets/octets received that exceeded the
allocated BR.
Number of packets/octets transmitted.
Number of packets that should have been transmitted,
but that were dropped due to lack of buffering resources.
show t3 vc qos stats
187