Cables and Cable Ties
The shipment does not include the cables required for the telephone side of your
network. Ensure that the installation site has the proper network cabling.
Cable ties are needed to bundle network and power cables, to provide access to
LTM and RLTM modules.
Service Console
You can connect a service console or a PC to the CVX 1800 to monitor startup
diagnostics and to perform manual startup and configuration. See
"Chassis Connections,"
following software manuals for information on configuring the CVX access
switches:
•
CVX Multi-Service Access Switch Startup Guide
•
CVX Multi-Service Access Switch Configuration Guide
Mounting Hardware
To install the CVX 1800 chassis in a rack, you need a Phillips #2 screwdriver and
a computer rack that meets the specifications listed in
page
If the rack does not have threaded rail holes, you must use cagenuts and cagenut
screws (not supplied).
296-1011-200 Rel. 5.0, Doc. Rev. 08.01
for information on installing a service console. See the
Note: Before you turn on the CVX 1800, you should connect a local
terminal or PC to the CVX 1800 console port. This console will display
diagnostic information if there is a startup problem, in which case, you
need to contact Nortel Networks Technical Support (see
Services"
on
page
xxiv).
1-7.
Metal Fascia Chassis Installation
Preparing for the CVX 1800 Installation
"Rack Requirements"
Chapter 3,
"Customer
on
1-15