Show T1 Ds1 Ansi Prm - Nortel Versalar 15000 Reference Manual

SES
UAS

show t1 ds1 ansi prm

The
MCT3 and MCOC3 channels, or for a specific slot. This command allows for the
following options:
-slot <value>
<value>
value is any of the
following:
<slot>
<slot/conn>
<slot/conn/chan>
The output includes the following information:
T1 over Mct3 ansi prm
Slot/Conn/Channel
PRMR0
PRMR1
PRMR2
PRMR3
PRMES
PRMSES
PRME
308689-B Rev 00
show t1 ds1 ansi prm
Number of severely errored seconds (SESs).
Number of unavailable seconds (UASs).
command displays ANSI PRM information for all
Displays PRM information for the specified slot only.
Displays information for the specified
slot/connector/channel.
Identifier for the slot, DS3 connector, and T1 channel.
Four 16-bit quantities that hold a complete copy of the
most recent PRM. Each PRM describes the preceding 4
seconds, with PRMR0 being the field which describes the
latest second and PRMR3 the field which describes the
oldest second.
Number of errored seconds (ESs) as reported in the
performance report messages.
Number of severely errored seconds (SESs) reported in
the performance report messages.
Number of erroneous performance report messages
received. PRME is counted if there is an error in:
• The C1/Carrier bit
• The HLDC header of the PRM
• The length of the PRM
This means that PRMEs are counted if bad frames are
sent on the Facility Data Link (FDL). If good messages
are sent which are not PRMs, the PRMEs are not
counted.
show t1 ds1 ansi prm
151