Show Logical-Line Summary - Nortel Versalar 15000 Reference Manual

show logical-line summary

show logical-line summary
The
information collected for a specified interface or slot.
This command allows for the following options:
-slot <slot>
-name <name>
<value>
The output includes the following information:
Logical line over Mct3 summary
Name
Slot/Conn/Chan/Index
Admin/Oper State
QoS Package
WAN Protocol
CRC
Rate Adaption
112
show logical-line summary
command displays all packet and octet
Displays information for the specified slot only.
Displays information for the specified circuit only.
Displays information for the specified circuit only.
User-defined name for the logical line.
Identifies the slot, DS3 connector, DS1 channel, and the l
index for this line instance.
The index ranges from 1 to 24 (for T1) and 1 to 31 (for
E1). This number differentiates multiple logical lines
configured on the same DS1.
Admin state is the configured state, either up or down.
Oper state is the operational state, either alarm or up.
QoS service package used for this line.
Indication of current protocol selection.
CRC size. Possible values are CRC-32 or CRC-16. When
you select CRC-32, a 32-bit CRC is appended to the
frame being transmitted and a 32-bit CRC check is
performed on the received frame. When you select
CRC-16, a 16-bit CRC is appended to the transmitted
frame and a 16-bit CRC is performed on the received
frame.
The number of bits and their bit positions within the
timeslot. Possible values are: adaption-64k and
adaption-56klsb. The 64k selection uses all 8 bits in the
timeslot, while the 56klsb selection uses 7 of the 8 bits.
Also, 56klsb does not use the least significant bit in the
timeslot.
308689-B Rev 00