Show Ip Static - Nortel Versalar 15000 Reference Manual

show ip static

-A
-s
The table includes the following information:
Destination/Mask
Proto
Age
Cost
NextHopAddr / AS
AS
show ip static
The
router. The output includes the following information:
IP Destination
Network Mask
Cost
Next Hop
92
show ip static command displays all statically configured routes on the
Displays the entire routing table; routes marked with an
asterisk (*) are routes in the normal routing table.
Displays the slot. If the address is 255.255.255.255, then
the cache will be the internal cache for this slot.
Destination IP address for this route and the subnet mask
to be combined with the destination address. This
combination is then compared with the value in
Destination. If the value of Destination is 0.0.0.0 (a
default route), then the value of Mask is also 0.0.0.0.
Routing method through which the router learned this
route: local, RIP, or OSPF.
Number of seconds since this route was last updated or
verified to be correct. The meaning of "too old" depends
on the routing protocol specified under Proto.
Number of hops to reach the destination.
IP address of the next hop of this route. If the next hop is
an unnumbered interface, the output includes 0.0.0. n ,
where n is the number of the circuit on which the interface
has been configured.
Autonomous system identifier for destination IP
interfaces running the OSPF protocol.
IP address of this static route.
Subnet mask for this static route.
Number of hops to reach the destination.
IP address of the next hop on the route. If the next hop is
an unnumbered interface, the Next Hop field displays the
circuit number associated with the unnumbered interface.
308689-B Rev 00