User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Dead Interval
Retransmit Interval
Transit Delay
config router ospf virtif create
This command creates the OSPF virtual interface for the specified <areaid> and <neighbor>. The
<neighbor> parameter is the IP address of the neighbor.
Format
config router ospf virtif delete
This command deletes the OSPF virtual interface from the given interface, identified by <areaid>
and <neighbor>. The <neighbor> parameter is the IP address of the neighbor.
Format
config router ospf virtif authtypekey
This command configures the authentication type and key for the OSPF virtual interface identified
by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The
value for <type> is either none or simple. The [key] is composed of standard displayable, non-
control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8 bytes
or less if the authentication type is simple password. If the key is cryptographic, the key may be up
to 256 bytes. Unauthenticated interfaces do not need an authentication key.
Default
Format
config router ospf virtif transdelay
This command configures the transit delay for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the
neighbor. The range for <seconds> is 0 to 3600 (1 hour).
Default
Format
8-26
The configured dead interval for the OSPF virtual interface.
The configured retransmit interval for the OSPF virtual interface.
The configured transit delay for the OSPF virtual interface.
config router ospf virtif create <areaid> <neighbor>
config router ospf virtif delete <areaid> <neighbor>
The default value for authentication type is none. The default password key is
not configured.
config router ospf virtif authtypekey <areaid>
<neighbor> <none|simple> [key]
1
config router ospf virtif interval transdelay <areaid>
<neighbor> <0-3600>
202-10009-01
Routing Commands