Config Garp Gvrp Adminmode; Config Garp Gvrp Interface Mode; Config Garp Jointimer; Config Garp Leavetimer - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

config garp gvrp adminmode

This command enables or disables GVRP.
Default
Format

config garp gvrp interface mode

This command enables or disables GVRP (GARP VLAN Registration Protocol) for a specific
port. If GVRP is disabled, Join Time, Leave Time and Leave All Time have no effect.
Default
Format

config garp jointimer

This command sets the GVRP join time per port and per GARP. Join time is the interval between
the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership
for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds)
Default
Format

config garp leavetimer

This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service.time is 20 to 600 (centiseconds).
Note: This command has an effect only when GVRP is enabled.
Default
Format
Switching Commands
disable
config garp gvrp adminmode <enable|disable>
disable
config garp gvrp interface mode <slot.port|all>
<enable|disable>
20 centiseconds (0.2 seconds)
config garp jointimer <slot.port/all> <10-100>
60 centiseconds (0.6 seconds)
config garp leavetimer <slot.port/all> <20-600>
202-10009-01
7-37