NETGEAR ProSafe GSM7312 User Manual page 143

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
This chapter provides detailed explanation of the Routing commands. The switch commands are
divided by functionality into these different groups:
• Show commands are used to display switch settings, statistics and other information.
• Config commands are used to configure features and options of the switch. For every config
command there is a show command that will display the config setting.
• Transfer commands are used to transfer configuration and informational files to and from the
switch.
Syntax conventions are described in
This chapter is organized by command type:
• "VLAN Routing" on page 8-2
• "Router Commands" on page 8-2
• "ARP Commands" on page 8-5
• "General IP Commands" on page 8-7
• "RIP Commands" on page 8-11
• "OSPF Commands" on page 8-14
• "Router Discovery Commands" on page 8-28
• "VRRP Commands" on page 8-30
• "BootP and DHCP Relay Commands" on page 8-34
Routing Commands
"CLI Command Format" on page
202-10009-01
Chapter 8
Routing Commands
5-1.
8-1