Transfer Upload Filename; Transfer Upload Datatype; Transfer Upload Start; Transfer Download Mode - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

transfer upload filename

This command sets the name for the file that is uploaded from the switch. The switch "remembers"
the last file name used.
Append the file path to the file name if the string is less than 31 characters. Otherwise, use the
"transfer upload path" command, and the File Name will be appended to the File Path.
Note: This command is valid only when the Transfer Mode is TFTP. See "transfer upload mode" .
Default
Format

transfer upload datatype

This command sets the type of file to upload from the switch.
Format
The datatype is one of the following:
config
errorlog
msglog
traplog

transfer upload start

This command starts an upload transfer after displaying current settings and upon confirmation.
Format

transfer download mode

This command specifies whether XMODEM or TFTP mode is used when uploading from the
switch.
Default
Format
7-76
Blank
transfer upload filename <name>
transfer upload datatype
<config|errorlog|msglog|traplog>
Configuration file.
Error log.
Message log.
Trap log (the default).
transfer upload start
xmodem. This is valid only when the transfer is initiated by the serial EIA 232
port.
transfer download mode <xmodem|tftp>
202-10009-01
Switching Commands