Config Lag Create; Config Lag Addport; Config Lag Deleteport - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Logical Slot.Port
Lag Name
Link State
Admin Mode
Link Trap Mode
STP Mode
Mbr Ports
Port Speed

config lag create

This command configures a new LAG and generates a logical slot and port number for it. Display
this number using the "show lag" on page 26.
Note: Before including a port in a LAG, set the port physical mode. See "config port
physicalmode" on page 26.
Format

config lag addport

This command adds one port to the LAG. The first interface is a logical slot and port number of a
configured LAG.
Note: Before adding a port to a LAG, set the physical mode of the port. See "config port
physicalmode" on page 26.
Format

config lag deleteport

This command deletes one or more ports from the LAG. The first interface is a logical slot and port
number of a configured LAG, and the second interface is a valid slot and port number that is a
member of any LAG or all (to delete all ports in the specified LAG).
Format
Switching Commands
The logical slot and the logical port.
The name of this lag. You may enter any string of up to 15 alphanumeric
characters.
Indicates whether the Link is up or down.
May be enabled or disabled by selecting the corresponding line on the pull-
down entry field. The factory default is enabled.
This object determines whether or not to send a trap when link status changes.
The factory default is enabled.
The Spanning Tree Protocol Administrative Mode associated with the port or
lag. The possible values are:
Disable - Spanning tree is disabled for this port.
Enable - Spanning tree is enabled for this port.
A listing of the ports that are members of this lag, in slot.port notation. There
can be a maximum of 8 ports assigned to a given lag.
config lag create <name>
config lag addport <logical slot.port> <slot.port>
config lag deleteport <logical slot.port>
<slot.port|all>
202-10009-01
7-27