User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Port Up Time Since
Counters Last Cleared
STP BPDUs Transmitted
STP BPDUs Received
RST BPDUs Transmitted
RST BPDUs Received
MSTP BPDUs Transmitted
MSTP BPDUs Received
config spanningtree port migrationcheck
This command forces the specified port to transmit RST or MST BPDUs. The port <slot.port> is
the desired switch port. To set the migration check for all ports with a single command, "all" can
be specified. Note that the forceversion parameter for the switch must be set to 802.1w or 802.1s.
Default
Format
config spanningtree port mode
This command sets the Administrative Switch Port State to a new value for the specified port. The
port <slot.port> is the desired switch port. To enable or disable all ports with a single command,
"all" can be specified. Note that only 4095 ports can be enabled.
Default
Format
show spanningtree bridge
This command displays spanning tree settings for the bridge.
Format
Bridge Priority
Bridge Identifier
Bridge Max Age
Bridge Hello Time
Bridge Forward Delay
Bridge Hold Time
7-48
Time since port was reset, displayed in days, hours, minutes, and seconds.
Spanning Tree Protocol Bridge Protocol Data Units sent.
Spanning Tree Protocol Bridge Protocol Data Units received.
Rapid Spanning Tree Protocol Bridge Protocol Data Units sent.
Rapid Spanning Tree Protocol Bridge Protocol Data Units received.
Multiple Spanning Tree Protocol Bridge Protocol Data Units sent.
Multiple Spanning Tree Protocol Bridge Protocol Data Units received.
disable
config spanningtree port migrationcheck <slot.port/
all> <enable/disable>
disable
config spanningtree port mode <slot.port/all>
<enable/disable>
show spanningtree bridge
Configured value.
TConfigured value.
Configured value.
Configured value.
Minimum time between transmission of Configuration Bridge Protocol Data
Units (BPDUs).
202-10009-01
Switching Commands