Config Router Route Default Create; Config Router Route Default Delete; Arp Commands; Show Arp Table - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Format

config router route default create

This command configures the default route. The value for <nexthopip> is a valid IP address of the
next hop router.
Format

config router route default delete

This command causes the static default route to be deleted.
Format

ARP Commands

show arp table

This command displays the Address Resolution Protocol (ARP) cache. The displayed results are
not the total ARP entries. To view the total ARP entries, the operator should view the show arp
table results in conjunction with the show arp switch results.
Format
Age Time (seconds)
Response Time (seconds)
Retries
Cache Size
IP Address
MAC Address
Interface
Type
Routing Commands
config router route preference <local/static> <0-255>
config router route default create <nexthopip>
config router route default delete
show arp table
The time it takes for an ARP entry to age out. This value was configured into the
unit. Age time is measured in seconds.
The time it takes for an ARP request timeout. This value was configured into the
unit. Response time is measured in seconds.
The maximum number of times an ARP request is retried. This value was
configured into the unit.
The maximum number of entries in the ARP table. This value was configured
into the unit.
The IP assigned to each interface.
The hardware MAC address that each interface maps to.
The associated slot.port which identifies an ARP entry.
The type that was configured into the unit. The possible values are Local,
Gateway, Dynamic and Static.
202-10009-01
8-5