Config Router Rip Interface Authtypekey; Config Router Rip Interface Defaultmetric; Config Router Rip Interface Mode; Config Router Rip Interface Version Receive - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

config router rip interface authtypekey

This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The
value of <type> is either none or simple.
The value for authentication key [key] must be 16 bytes or less. The [key] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard.
Default
Default
Format

config router rip interface defaultmetric

This command specifies the metric value that is to be used for the default route entry (0.0.0.0 with
subnet mask = 0.0.0.0) in RIP updates originating from this interface.Valid values for <metric>
range from 0 to 15.
Note that a metric value of 0 suppresses default route originations (although a default route may be
propagated on this interface from another router). A metric value of 1 instructs the router to always
advertise a default route entry with a metric of 1 in its route update messages, which could
adversely affect network operation.
Default
Format

config router rip interface mode

This command enables or disables RIP on a router interface. The value for <mode> is either enable
or disable.
Default
Format

config router rip interface version receive

This command configures the interface to allow RIP control packets of the specified version(s) to
be received.
Routing Commands
The default authentication type is none.
The default password key is an empty string. Unauthenticated interfaces do not
need an authentication key.
config router rip interface authtypekey <slot.port>
<none|simple> [key]
0
config router rip interface defaultmetric <slot.port>
<0-15>
disable
config router rip interface mode <enable|disable>
202-10009-01
8-13