Config Network Javamode; Config Prompt; Show Serial - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Default
Format

config network javamode

This command specifies whether or not the switch should allow access to the Java applet in the
header frame of the Web interface. When access is enabled, the Java applet can be viewed from the
Web interface. When access is disabled, the user cannot view the Java applet.
Default
Format

config prompt

This command changes the name of the prompt. The length of name may be up to 64 alphanumeric
characters.
Default
Format

show serial

This command displays serial communication settings for the switch.
Format
Serial Port Login Timeout
(minutes)
Baud Rate
Character Size
Flow Control
Stop Bits
Parity Type
Switching Commands
enable
config network webmode <enable|disable>
enable
config network javamode <enable|disable>
<model #>
config prompt <system prompt>
show serial
Specifies the time, in minutes, of inactivity on a Serial port connection, after
which the Switch will close the connection. Any numeric value between 0 and
160 is allowed, the factory default is 5. A value of 0 disables the timeout.
The default baud rate at which the serial port will try to connect. This is selected
from a pull-down menu. The available values are 1200, 2400, 4800, 9600,
19200, 38400,57600, and 115200 baud. The factory Default is 9600 baud.
The number of bits in a character. The number of bits is always 8.
Whether Hardware Flow-Control is enabled or disabled. Hardware Flow
Control is always disabled.
The number of Stop bits per character. The number of Stop bits is always 1.
The Parity Method used on the Serial Port. The Parity Method is always None.
202-10009-01
7-15