User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
show switchconfig
This command displays switch configuration information.
Format
Broadcast Storm Recovery
Mode
802.3x Flow Control Mode
config switchconfig broadcast
This command enables or disables broadcast storm recovery mode. If the mode is enabled,
broadcast storm recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in "Broadcast Storm Recovery
Thresholds" table) of the link speed, the switch discards the broadcasts traffic until the broadcast
traffic returns to the low threshold percentage or less. The full implementation is depicted in the
"Broadcast Storm Recovery Thresholds" table.
Table 2. Broadcast Storm Recovery Thresholds
Link Speed
10M
100M
1000M
Format
config switchconfig flowcontrol
This command enables or disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Default
Format
show port
This command displays port information.
7-24
show switchconfig
May be enabled or disabled by selecting the corresponding line on the pull-
down entry field. The factory default is disabled.
May be enabled or disabled by selecting the corresponding line on the pull-
down entry field. The factory default is disabled.
High
20
5
5
config switchconfig broadcast <enable/disable>
enable
config switchconfig flowcontrol <enable/disable>
202-10009-01
Low
10
2
2
Switching Commands