User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Solution 1
All traffic entering the ports is tagged traffic. Since the traffic is tagged, the PVID configuration
for each port is not a concern. The network card configuration is as follows:
•
Devices on Project A should tag all traffic with 'VLAN 2'
•
Devices on Project B should tag all traffic with 'VLAN 3'
•
Devices on Project C should tag all traffic with 'VLAN 4'
•
Devices on Project P should tag all traffic with 'VLAN 9'
Solution 2
The network card configuration for devices on Project A, B and C should be set to NOT tag traffic.
To take care of these untagged frames configure the following:
•
config vlan ports pvid 2 0.1
•
config vlan ports pvid 2 0.2
•
config vlan ports pvid 3 0.3
•
config vlan ports pvid 3 0.4
•
config vlan ports pvid 4 0.5
•
config vlan ports pvid 4 0.6
Quick Startup
202-10009-01
6-13