User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Quick Startup Uploading from Switch to Out-of-Band PC (Only
XMODEM)
Table 6-5.
Quick Startup Uploading from Switch to Out-of-Band PC (Only XMODEM)
Command
transfer upload mode xmodem
transfer upload datatype
<config|errorlog|systemtrace|traplog>
transfer upload start
Quick Startup Downloading from Out-of-Band PC to Switch (Only
XMODEM)
Table 6-6.
Quick Startup Downloading from Out-of-Band PC to Switch (Only XMODEM)
Command
transfer download mode xmodem
transfer download datatype <config/code>
transfer download start
Quick Startup Downloading from TFTP Server
Before starting a TFTP server download, the operator must complete the Quick Startup for the IP
Address.
6-6
Details
Changes mode to xmodem which is initiated by the
serial EIA 232 port
The types are:
config - configuration file
errorlog - error log
system trace - system trace
traplog - trap log
This starts the upload and also displays the mode of
uploading and the type of upload it is and confirms
the upload is taking place.
For example:
If the user is using HyperTerminal, the user must
specify where the file is going to be received by the
PC.
Details
Makes the download mode to be xmodem
Sets the download datatype to be an image or
config file.
The default is a code file.
For example:
If the user is using HyperTerminal, the user must
specify which file is to be sent to the switch.
The Switch will restart automatically once the
code has been downloaded.
202-10009-01
Quick Startup