Config Acl Rule Match Dstl4Port Range; Config Acl Rule Match Every; Config Acl Rule Match Ipdscp - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

config acl rule match dstl4port range

This command specifies a destination layer 4 port match condition for an ACL rule referenced by
the and
<aclid> <rulenum>
last ports that are part of the port range. They have values from 0 to 65535. The ending port must
have a value equal or greater than the starting port. The starting port, ending port, and all ports in
between will be part of the destination port range.
Either this command or the
specify a destination layer 4 port range as a match condition.
Format
config acl rule match dstl4port range <aclid> <rulenum> <startport>
<endport>

config acl rule match every

This command specifies a match condition in which all packets match for an ACL rule referenced
by the and
<aclid> <rulenum>.
every match condition.
Format
config acl rule match every <aclid> <rulenum> <true/false>

config acl rule match ipdscp

This command specifies the IP DiffServ Code Point (DSCP) field for an ACL rule referenced by
the and
<aclid> <rulenum>.
octet in the IP header. The
0 to 63.
The commands to match IP DSCP, IP precedence, and IP TOS are alternative ways to specify a
match criterion for the same Service Type field in the IP header, however each uses a different user
notation.
Format
config acl rule match ipdscp <aclid> <rulenum> <dscpval>
10-4
. The
<startport>
config acl match destl4port keyword
The parameter
The DSCP is defined as the high-order six bits of the Service Type
parameter identifies the DSCP field and is an integer from
<dscpval>
202-10009-01
and parameters identify the first and
<endport>
indicates to reinforce or negate
<true/false>
command may be used to
ACL Commands