Config Protocol Interface Add; Config Protocol Interface Remove; Show Garp Info; Show Garp Interface - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

config protocol interface add

This command adds the physical
. If
<groupid> <all>
group may have more than one interface associated with it. Each interface and protocol
combination can only be associated with one group. If adding an interface to a group causes any
conflicts with protocols currently associated with the group, this command will fail and the
interface(s) will not be added to the group.
Default
Format

config protocol interface remove

This command removes the
by this . If
<groupid>
Default
Format

show garp info

This command displays Generic Attributes Registration Protocol (GARP) information.
Format
GMRP Admin Mode
GVRP Admin Mode

show garp interface

This command displays Generic Attributes Registration Protocol (GARP) information for one or
all interfaces.
Format
Interface
Join Timer
Switching Commands
<slot.port>
is selected, all physical interfaces will be added to this protocol group. A
none
config protocol interface add <groupid> <slot.port/
all>
from this protocol-based VLAN group that is identified
<interface>
is selected, all ports will be removed from this protocol group.
<all>
none
config protocol interface remove <groupid>
<slot.port/all>
show garp info
This displays the administrative mode of GARP Multicast Registration Protocol
(GMRP) for the system.
This displays the administrative mode of GARP VLAN Registration Protocol
(GVRP) for the system.
show garp interface <slot.port/all>
This displays the slot.port of the interface that this row in the table describes.
Specifies the interval between the transmission of GARP PDUs registering (or
re-registering) membership for an attribute. Current attributes are a VLAN or
multicast group. There is an instance of this timer on a per-Port, per-GARP
202-10009-01
interface to the protocol-based VLAN identified by
7-35