User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
User
show users authentication
This command displays all user and all authentication login information. It also displays the
authentication login list assigned to the default user.
Format
User
System Login
802.1x Port Security
System Utilities
This section describes system utilities.
save config
This command permanently saves configuration changes to Non-Volatile Random Access
Memory (NVRAM).
Format
logout
This command closes the current telnet connection or resets the current serial connection.
Note: Save configuration changes before logging out. See "save config" on page 74.
Format
transfer upload mode
This command specifies whether XMODEM or TFTP mode is used when uploading from the
switch.
Default
7-74
This field displays the users configured locally to have access to the specified
port.
show users authentication
This field lists every user that has an authentication login list assigned.
This field displays the authentication login list assigned to the user for system
login.
This field displays the authentication login list assigned to the user for 802.1x
port security.
save config
logout
xmodem. This is valid only when the transfer is initiated by the serial EIA 232
port.
202-10009-01
Switching Commands