User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Table 6-7.
Quick Startup Downloading from TFTP Server
Command
transfer download mode TFTP
transfer download datatype <config/code>
transfer download filename <name>
transfer download serverip <ipAddr>
transfer download start
Quick Startup Factory Defaults
Table 6-8.
Quick Startup Factory Defaults
Command
clear config
save config
reset system OR Cold Boot the
Switch
Quick Startup
Details
Makes the download mode to be TFTP
Sets the download datatype to be an image or
config file.
The default is a code file.
The name can ONLY be an image file or a
configuration file of the switch.
The IP Address is the source IP Address.
Starts the TFTP download
Details
Enter yes when the prompt pops up to clear all the configurations
made to the switch.
Enter yes when the prompt pops up that asks if you want to save the
configurations made to the switch.
Enter yes when the prompt pops up that asks if you want to reset the
system.
This is the users choice either reset the switch or cold boot the
switch, both work effectively.
202-10009-01
6-7