Ricoh Aficio MP C3001 Service Manual page 1212

System SP5-xxx
3: Egret controller
4 to 10: Reserved
5195 [Limitless SW] DFU
-
Selects the paper feed mode.
Productivity priority:
001
This changes the feeding tray as soon as the machine detects the priority tray
even the paper still remains in the feeding tray.
Tray priority:
This changes the feeding tray after the paper in the tray where the machine
has been feeding paper has been run out of.
This SP is activated only when a customer selects the "Auto Paper Selsct".
5196
[90 degree rotation (copy)] JPN only
001 -
5199 [Paper Exit After Staple End.]
001 -
Enables or disables the paper feeding out from the finisher without stapling.
If this setting is "1: ON", paper is fed out without stapling at the maximum
number of the finisher stapling when the machine gets a multiple printing
job (over maximum number).
If this setting is "0: OFF", paper is fed out with stapling at the maximum
number of the finisher stapling when the machine gets a multiple printing
job (over maximum number).
D086/D087
[0 or 1 / 0 / -]
*CTL 0: Productivity priority
1: Tray priority
*CTL -
[ 0 or 1 / 0 / -]
*CTL
0: OFF, 1: ON
3-232 SM Appendix