Ricoh Aficio MP C3001 Service Manual page 995

1108 [After Reload/Job Target Temp.]
Center
001
Specifies the temperature of the heating roller after re-load or job.
Press
002
Specifies the temperature of the pressure roller after re-load or job.
1111 [Environment Correction:Fusing]
Temp.: Threshold: Low
Specifies the threshold temperature for low temperature. If the fusing
001
temperature is 17°C or less, the machine executes the fusing mode for low
temperature.
Temp.: Threshold: High
Sepcifies the threshold temperature for high temperature. If the fusing
002
temperature is 30°C or more, the machine executes the fusing mode for high
temperature.
Low Temp. Correction
Specifies the additional temperature for the target temperature. If the fusing
003
temperature is in low temperature condition, this temperature is added to the
taraget temperature.
High Temp. Correction
Specifies the additional temperature for the target temperature. If the fusing
004
temperature is in high temperature condition, this temperature is added to the
taraget temperature.
Job Low Temp.
005
Correction
Job High Temp.
006
Correction
007 Job Low Temp.
SM Appendix
*ENG [120 to 180 / 150 / 1 deg/step]
*ENG
[100 to 200 / 120 / 1 deg/step]
*ENG
[0 to 100 / 17 / 1 deg/step]
*ENG [0 to 100 / 30 / 1 deg/step]
*ENG [0 to 15 / 5 / 1 deg/step]
*ENG [0 to 15 / 0 / 1 deg/step]
*ENG [0 to 100 / 5 / 0.1 deg/step]
*ENG
[0 to 100 / 0 / 0.1 deg/step]
*ENG [0 to 100 / 10 / 0.1 deg/step]
3-15
System SP1-xxx
D086/D087