Ricoh Aficio MP C3001 Service Manual page 1590

Error Codes
Code Meaning
15-95 Transfer Station Function
Original length exceeded
22-00
the maximum scan length
Memory overflow while
22-01
receiving
Tx or rx job stalled due to
22-02 line disconnection at the
other end
The machine cannot store
22-04
received data in the SAF
No G3 parameter
22-05
confirmation answer
Data read timeout during
23-00
construction
The machine software
resets itself after a fatal
25-00
transmission error
occurred
D393
Suggested Cause/Action
incoming e-mail did not match the ID code
registered in the machine.
The machine rejected an incoming e-mail for
transfer because the transfer function was
unavailable.
Divide the original into more than one page.
Check the resolution used for scanning. Lower
the scan resolution if possible.
Add optional page memory.
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to an
another fax machine, if the machine's printer is
busy or out of order.
Add an optional SAF memory card or hard
disk.
The job started normally but did not finish
normally; data may or may not have been
received fully.
Restart the machine.
Update the ROM
Replace the FCU.
Defective FCU board or firmware.
Restart the machine.
Replace the FCU.
Update the ROM
Replace the FCU.
42 SM