3 Replacing the fusing film
After replacing the fusing film carry out adjustment:" Adjusting the
Note:
pressure of the fusing film drive roller".
Removing the fuser unit
Open the front door
1
Open the output door
2
Release the refeed unit.
3
Remove the inner cover (1) from the fuser (1 screw).
4
Cut the cable tie, and disconnect the connector. Then, remove the fuser (3
5
screws).
Removing the upper fuser
Warning:
Do not touch the outer surface of the fusing film. If necessary, protect the fusing
film with paper.
Do not touch any paint-locked screws
Detach the springs.
1
408
TSM Océ 3121
Before dismantling the unit, place paper under the unit.
spring
spring
Dis-/assembly